Gel Filter Cartridge Inoculant

Product Weight: 0.00  lbs

Product Dimensions: 12.00"(Length) x12.00"(Width);12.00(Height);

Features:

• Contains 54 million CFU* per ml of gel
• Immediately establishes biological activity
• Quickly stabilizes aquarium environments
• Use when inserting a new cartridge in your filter or after every cartridge cleaning
• Use whenever placing new filters media in your aquarium filtering system
• Colony forming units
MICROBE-LIFT gel filtration cartridge inoculants is a technological breakthrough because it is the first product that lets you put the bacteria right where you want it and it stays there.

MICROBE-LIFT gel filter cartridge inoculants will quickly attach to and populate all brands of filter cartridges and all styles of media including foam, floss, bio-balls, ceramic media, etc. This will help rapidly establish the necessary biological activity in your filter to stabilize your aquarium’s environment quickly. It will also help to restore the activity to your filter when you clean or change the media and when you replace your filter cartridge.

• Easily applies to filter cartridge pads or media without running or getting messy.
• It contains naturally occurring bio-polymers that help the organisms quickly attach to media allowing for 80% reduction in filter start up time.
• Helps to stabilize aquarium environment quickly upon start up and eliminates transient instability that can occur when filter media is cleaned or replaced. You should replace your filter cartridge after every 6 inoculations.
• Allows for more frequent cleaning of filters without subsequent instability if an aquarium has had a high solids loading where frequency of cleaning is beneficial.
• Reduces the frequency of cleaning by accelerating the breakdown of organic solids that can lead to high maintenance requirements.
• Helps establish de-nitrification in the filter; which can lower nitrate levels in the aquarium.

Directions:
Inoculate (spread) Microbe-Lift gel filtration cartridge directly onto your filter pad or media. The GEL will absorb into the filter pad or media. Allow the GEL to set for 1 to 2 hours before inserting back into the filter. Inoculate (spread) gel into each corner of the filter cartridge. If your filter cartridge pad is rectangular (like a photo) add 2 more drops in the middle of the cartridge. After Insertion turn-off the recirculating pump for one to two hours, providing the water can maintain adequate oxygenation without circulating for this amount of time.

Repeat application of GEL with each cleaning or replacement of filter pads or filter media. Use when nitrate levels exceed 0.6 mg/L or as needed to maintain optimum performance of your filter or skimmer.

Note: Saltwater slows down bacterial action, for faster results in marine environments apply more gel.

Cautions:
• Avoid contact with eyes
• Use gloves to avoid contact with skin and open wounds. If exposed wash with soap and water
• Do not use internally
• Keep out of reach of children